1. 1

    To invite experienced and qualified professional person to install the faucet. When installing, the faucet should try not to bump with a hard object, not the building material residue left on the surface, so as not to damage the surface gloss chrome coating. Note that clearing all impurities inside the pipe before installing faucet.

  2. 2
    • 2.1 Installation should completely remove all impurities inside the pipes. To avoid damage to the cartridge, jamming, clogging and leakage. Surface should be cleaned so that it does not leave residue of building materials.
    • 2.2 any kind of faucet products are used without the use of excessive force during the switch, just gently twist or slide can be. Even the traditional taps, nor do they need to spend a lot of effort to twist to the dead. Especially not to handle or use as a handrail to support. Outlet mesh hould be demolished to remove impurities after a period of time . Flexible hose should be paid attention to the natural stretch hose in order to avoid breaking.
    • 2.3 bath faucet metal hose should be kept natural stretch state. Also, when using or not, pay attention to the joints do not form dead angle in order to avoid broken or damaged hose.
    • 2.4 for a long time without use,maybe the faucets will be non-completely closed, leakage, handle loose connector loose leakage and so on, under normal circumstances, consumers can solve their own.
    • 2.5 when slowing-open faucet can’t close completely. Usually due to a hard card, simply remove the debris after demounting the handle (hand wheel), unscrew the cartridge nut or cartridge, after the removal of impurities as is installed can resume normal use.
    • 2.6 If ceramic cartridge faucet can not be closed completely, maybe debris scratches sealing surface or applied force to ceramic cartridge is not enough. If the former reason, please ask the faucet manufacturer service department or professional peason to repair. If the latter reason, users simply remove the handle (hand wheel) and slightly tighten the cartridge nut again.
    • 2.7 handle (hand wheel) is loose under normal circumstances because of the negligence of the fastening assembly, simply tighten the fixing screw. Or useing a very long time, wear and tear resulting in the gap increases, generally without remedy,accessories should be replaced.
    • 2.8 In case of faucets joints leaking, usually caused by the assembly parts are not screwed tight, just tighten. Sometimes, a faucet is perfect in all aspects, but dripping constantly after close. Then it depends on the driping time and the number of water droplets. Longer time may sometimes continue dripping 4 to 5 minutes, in total about a dozen drops which is equivalent to faucet mouth water,it is a normal phenomenon.
  3. 3
    • 3.1 faucet surface should always be wiped gently with a soft cloth (without impurities) diping a cleaning agent. Can not be used with a stiff wire or hard particles cleaning cloth. In addition, the phase must not be hit with a hard surface so bruised faucets. Can not be hit with a hard object in order to avoid damage the faucet surface.
    • 3.2 Use the following cleaning agents to remove coarse solid mask and debris: mild liquid glass cleaner, pure liquid glass cleaner, acid-free, non-abrasive gentle liquid or completely dissolved powder, non-friction solution polish.
    • 3.3 Do not use any abrasive cleaners, cloth or paper cloth; Do not use any cleaners containing acid, polished or rough cleaner friction agent.
    • 3.4 if pressure is not less than 0.02mpa (0.2kgf/cm2), and after a period of time, the amount of water is reduced, or even gas water heater is off, you can gently unscrew the aerator mesh and remove impurities . Generally, faucets can be returned to normal.